WSEAS Transactions on Power Systems
Print ISSN: 1790-5060, E-ISSN: 2224-350X
Volume 18, 2023
Out-of-Step Detection based on Phasor Measurement Unit
Authors: , ,
Abstract: The electrical power systems operate as a huge, interconnected network that extends across a large area. In the power system, there is an equilibrium between generated power and a load. Any disturbance in the system, such as a fault or a change in load, will lead to imbalance and electromechanical oscillations. As a result, the power flow between two areas varies. This is known as a power swing." Large system disturbances could lead to large rotor angle deviations between groups of generators, resulting in a loss of synchronism between generators or between interconnected systems. This is known as an out-of-step condition. To avoid equipment damage and power outages, the interconnected area must be isolated as soon as possible before the electrical system loses synchronization. In this paper, PMU data is used to measure the current, voltage, and phase angle of the three phases at both ends of two interconnected area power systems. The measured data is then used to distinguish between a power swing or fault condition and predict the future phase angle difference during the disturbances to evaluate the system stability condition. If a swing is detected, then it will be ascertained whether the swing is stable or not. The performance of the proposed method has been tested on a simulated system using MATLAB / Simulink software.
Search Articles
Keywords: Phasor Measurement Unit, Current Detection Element, Phase Angle Difference, Phasor Current Difference, Out of step trip, Stability system
Pages: 354-363
DOI: 10.37394/232016.2023.18.36