WSEAS Transactions on Heat and Mass Transfer
Print ISSN: 1790-5044, E-ISSN:, E-ISSN: 2224-3461
Volume 16, 2021
On the Solution to Pre- Buckling of a Thin Rectangular Plate Subjected to a Thick Strip in-plane Loading
Author:
Abstract: The current paper deals with the problem of the simply supported thin rectangular plate subjected to the intermediate strip in-plane loading. Based on the strain energy method (Fourier ansatz), the critical (minimum value) of buckling stress occurrence was determined in a general form dependent only on the strip thickness, strip location, plate width and stress magnitude. Compatible with the classical columns Euler method it was found that the plate stability is decreased with the increasing of the plate width due to larger induced stresses. Also, strip location relative to the support region was found to influence the buckling (same analogy to the Euler buckling theory; consider the strip as a both sides pressed rod). Additionally, the strip width parameter increase is likely to cause larger buckling stress. Moreover, expressions that includes both axial and transverse loads for different extended cases configurations were also derived and examined based on the strain energy method alongside explanation for possible applications (thin aluminum plate welding). In a general view, it was found that the cases of combined axial and perpendicular loading action are less stabilized than cases where only one kind of loading configuration is participated. Finally, the buckling stress was found to agree qualitatively with the cited literature.
Search Articles
Pages: 198-207
DOI: 10.37394/232012.2021.16.23