WSEAS Transactions on Systems and Control
Print ISSN: 1991-8763, E-ISSN: 2224-2856
Volume 15, 2020
(Special Issue: Advanced Control and Diagnosis Systems in Mechatronic Engineering, https://www.wseas.org/cms.action?id=23210, Organizer - Guest Editor: Prof. Jerzy Garus) The Experimental Investigation of Using Thermography Inspection for Dry Turning Process Diagnosis
Author:
Abstract: Increasing the productivity and the quality of the machined parts are the main challenges of metal-based industry. There has been increased interest in monitoring all aspects of the machining process. When cutting metals and alloys most of the energy required to form the chips is converted into heat. Therefore, the temperatures generated in the cutting zone are an important factor to take into consideration. This factor is of a major importance to the performance of the cutting tool and quality of the work piece. Temperature at the cutting point of the tool is then a crucial parameter for controlling the course of turning process.Temperature monitoring by used of thermovision cameras provides a lot of information about thermal behavior of machines, tools and processes since they monitor large areas during normal operation. The article presents the research results referring to the observation of changes of cutting zone temperature with cutting parameters during turning of AW-7020.
Search Articles
Pages: 431-438
DOI: 10.37394/23203.2020.15.43