WSEAS Transactions on Electronics
Print ISSN: 1109-9445, E-ISSN: 2415-1513
Volume 12, 2021
Microcontroller Based High Voltage, High Speed Trigger Control Circuit for SMARTEX-C
Authors: , , , ,
Abstract: Microcontroller based trigger control circuit for fast pulsing of electrode potentials on wide range of time scales has been designed, installed, and tested for electron plasma experiments which are carried out in partial toroidal trap SMall Aspect Ratio Toroidal Electron plasma EXperiment in C – shaped geometry (SMARTEX – C), a device to create and confine non-neutral plasma (electron plasma). The sequence of trap operation is inject-hold-dump for which electrodes need to be pulsed with applied voltages at a high switching speed of few nanoseconds. Also this sequence of operation needs to be controlled over a very wide range of time scales from few microseconds to few seconds. As the available COTS (Commercial-Off-The-Shelf) high voltage DC power supplies generally do not provide this feature of fast switching at nanosecond time scale, MOSFET based circuit is developed which provides fast switching in the range of 20 – 100 nanoseconds of high voltages (200Vdc - 500Vdc) of multiple electrodes. The timing pulse widths of these trigger pulses are controlled using a microcontroller-based circuit. This experimental set-up also requires the triggering of a high current dc power supply used for an Electro-magnet (Toroidal Field Coil) to generate a toroidal magnetic field, at the start of this experiment. For this purpose, a Silicon Controlled Rectifier (SCR) based circuit is used. The gate pulse to trigger the SCR circuit is also generated from this microcontroller-based circuit. National Instrument’s LabVIEW software based Graphical User Interface (GUI) is developed for triggering the SCR and electrodes with a programmable time period through the serial link.
Search Articles
Pages: 100-105
DOI: 10.37394/232017.2021.12.14