WSEAS Transactions on Heat and Mass Transfer
Print ISSN: 1790-5044, E-ISSN: 2224-3461
Volume 12, 2017
Transient Simulation of the Hydrogen-Assisted Self-Ignition of Fuel-Lean Propane-Air Mixtures in Platinum-Coated Micro-Combustors Using Reduced-Order Kinetics
Authors: ,
Abstract: Transient simulation of the hydrogen-assisted self-ignition of propane-air mixtures under ambient condition were carried out in platinum-coated micro-combustors, using a two-dimensional model with reduced-order reaction schemes, heat conduction in the solid walls, convection and surface radiation heat transfer. The self-ignition behavior of the hydrogen-propane mixed fuel is compared for the case of heated feed is analyzed. Simulations indicate that hydrogen can successfully cause self-ignition of propane-air mixtures in catalytic micro-channels with a 0.2 mm gap size, eliminating the need for startup devices. The minimum hydrogen composition for propane self-ignition is found to be in the range of 0.8-2.8 % (on a molar basis), and increases with increasing wall thermal conductivity, and decreasing inlet velocity or propane composition. Higher propane-air ratio results in earlier ignition. The ignition characteristics of hydrogen-assisted propane qualitatively resemble the selectively inlet feed preheating mode. Transient response of the mixed hydrogen-propane fuel reveals sequential ignition of propane followed by hydrogen. Front-end propane ignition is observed in all cases. Low wall thermal conductivities cause earlier ignition of the mixed hydrogen-propane fuel, subsequently resulting in low exit temperatures. The transient-state behavior of this micro-scale system is described, and the startup time and minimization of hydrogen usage are discussed.
Search Articles
Keywords: Micro-combustion, Catalytic combustion, Transient combustion modelling, Platinum catalyst, Self-ignition, Reduced-order kinetics
Pages: 164-173
WSEAS Transactions on Heat and Mass Transfer, ISSN / E-ISSN: 1790-5044 / 2224-3461, Volume 12, 2017, Art. #19